Thingiverse
modified spool roller
von Mr_Saint
2
Downloads
1
Likes
0
Makes
Quick remix to add 45-degree (roughly) chamfers so that there's no need for supports.
This is sized to take a "608" bearing in each end and then those attach to end plates from BiscuitsOnTheFloor's "Yet Another Filament Spool Holder."
Two needed to make a proper device, so four bearings needed.
This is sized to take a "608" bearing in each end and then those attach to end plates from BiscuitsOnTheFloor's "Yet Another Filament Spool Holder."
Two needed to make a proper device, so four bearings needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!