Thingiverse
ModMic Headphone Mount
von danielzn
3
Downloads
5
Likes
0
Makes
Designed for the Antlion ModMic Uni/USB. I made this so that I would not have to use the double sided tape on my nice new headphones.
This one was made to be attached to the headband of the Phillips Fidelio X2HR. I'm sure that minor adjustments to the clasp area will allow this to work on other headphones.
You should be able to get away with 0.12mm quality, but I wouldn't go much higher, especially on the Mic Mount piece.
2x Clip Bolt
1x Headphone Clip
1x Mic Mount
The Mic Mount piece requires supports and should be printed with the magnet hole facing up. This piece also requires the addition of a 5x2mm circular fridge magnet that can be purchased elsewhere.
I also used adhesive foam pads along the inside of the clasp area so that this wouldn't damage the headphones.
This one was made to be attached to the headband of the Phillips Fidelio X2HR. I'm sure that minor adjustments to the clasp area will allow this to work on other headphones.
You should be able to get away with 0.12mm quality, but I wouldn't go much higher, especially on the Mic Mount piece.
2x Clip Bolt
1x Headphone Clip
1x Mic Mount
The Mic Mount piece requires supports and should be printed with the magnet hole facing up. This piece also requires the addition of a 5x2mm circular fridge magnet that can be purchased elsewhere.
I also used adhesive foam pads along the inside of the clasp area so that this wouldn't damage the headphones.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!