Thingiverse
ModMic Holder (Mic Part)
door MisterIXI
0
Downloads
1
Likes
0
Makes
Very basic clip for the modmic Microphone.
I only did a few iterations that it feels good enough. I wanted to not glue the magnet in place since that was the first thing failing on the original.
The cross is intentionally too thin to print well, it just needs to keep the magnet from falling out.
If I iterate further on the design I will update the file here.
(The original magnet or a similar one is obviously required, but nothing else)
I only did a few iterations that it feels good enough. I wanted to not glue the magnet in place since that was the first thing failing on the original.
The cross is intentionally too thin to print well, it just needs to keep the magnet from falling out.
If I iterate further on the design I will update the file here.
(The original magnet or a similar one is obviously required, but nothing else)
MisterIXI publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
