Thingiverse
Modular 4-Layer Jewelry Box Organizer | Stackable Design
door funformahn
2
Downloads
6
Likes
0
Makes
English Version
Design Concept:
This modular 4-layer jewelry box was designed to combine functionality, strength, and a clean modern look. Each level serves a specific purpose — from larger compartments for bracelets or watches to smaller divided sections for earrings or rings. The structure focuses on practicality and easy assembly, ensuring durability while maintaining a stylish aesthetic for everyday use.
Print Settings:
• Printer: Creality K1 / K1C
• Layer height: 0.20 mm (recommended for good detail and speed)
• Infill: 20–25% (Grid or Gyroid for best strength)
• No supports required
• Material: PLA or PETG
• Approximate print time: 10–12 hours total (all layers)
Assembly Instructions:
The jewelry box consists of four stackable modules:
1. Bottom base: solid piece that supports the structure.
2. Lower compartment module: includes dividers and a circular alignment pin at the center.
3. Upper compartment module: similar structure with a lower rim protrusion that fits int
Design Concept:
This modular 4-layer jewelry box was designed to combine functionality, strength, and a clean modern look. Each level serves a specific purpose — from larger compartments for bracelets or watches to smaller divided sections for earrings or rings. The structure focuses on practicality and easy assembly, ensuring durability while maintaining a stylish aesthetic for everyday use.
Print Settings:
• Printer: Creality K1 / K1C
• Layer height: 0.20 mm (recommended for good detail and speed)
• Infill: 20–25% (Grid or Gyroid for best strength)
• No supports required
• Material: PLA or PETG
• Approximate print time: 10–12 hours total (all layers)
Assembly Instructions:
The jewelry box consists of four stackable modules:
1. Bottom base: solid piece that supports the structure.
2. Lower compartment module: includes dividers and a circular alignment pin at the center.
3. Upper compartment module: similar structure with a lower rim protrusion that fits int
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
