Modular Adjustable Door Sweep

This is a modular adjustable door sweep designed to be printed out of a flexible material like Nylon or NinjaFlex. The three slots allow for individual sections to be adjusted for both height and angle so that they can be tailored to glide over an uneven floor. Each is 200mm in length so 4 of them are needed to fit a standard door. When attaching them gently tighten the center screw first until there is just enough friction to keep the sweep parallel to the floor and as low as it will go. Then open and close the door once. This will adjust the sweep to the highest position needed to clear the floor. After that tighten the center and outer two screws. The sweep should now be as low as possible without catching on the floor.