MODULAR ANT FARM/FORMICARIUM

Step 1: Print the filesYou need 4 of part 4 and 1 of the water tower. If you are starting with one module, you need 3 plugs and 1 connector. (or no connector if you use vinyl tubing to connect to the outworld; if you are, use 10mm OD tubing. You will need connectors to expand the nest though) Tip: You can wrap some tape around the connectors and plugs to make them fit more snugly if they are loose. Step 2: Clean up the partsIf you used the print settings, you will need to cut off the brim and will likely have to remove stringing and sand any faults in the print. (for the mold pattern and mold shell, you will need to have extra clean parts) Step 3: Make the moldTo make the mold, simply place the mold pattern centered in the mold shell. I would also recommend putting a small amount of silicone glue on the bottom of the mold pattern. Materials in this step:Silicone glue</i