Modular Box

Fully & eaisly customizable box
-very easy screw in modules
-lots of options
-available development plates available
-example I have put together is for ts100, but this can be for anything

Available parts & modules
-Box top & Box bottom, which need to be connected with 1mm wire & 4x5mm magnet balls (be sure to match polarity of balls when inserting them
-all of the modules are mounted with mounting screw, which screws into the rail
-big & small boxes with sliding lid or just a slide in rim
-boxes with hinges, which will need 1mm wire and can use 5mm magnet ball to close
-solder holder & screw to hold it (10 mm inner radius)
-helping hand base & flux pot with cap
-ts100 & spare tip holder, there is quite a few options to choose from
-LED light switch & LIPO module: I've used switch recycled from thompson DSL modem/router, recycled 5050 LED and 1s LIPO I had laying arround. Had to add 3.3V regulotor & resistor to make it work