Modular-Customizable Can Dispenser

Quick Starter GuideI recommend printing a set of side panels (220 × 400 mm) and then choosing the right peg length (can height) to fit your needs. Maximum can diameter: 70 mm. UPDATE (15.01.2025) - Documentation UpgradeAs mentioned in the comments, this little project has grown quite a bit and become a bit unwieldy for new users. To help newcomers get started more easily, I’ve decided to provide a short introduction and make some minor changes to the profile names to reduce confusion. 😊Principal ModelThe original model consisted of the master panels and a corresponding set of pegs, customized to fit the height of your cans. The maximum supported diameter is approximately 85 mm (suitable for German/European tuna cans), but smaller cans are no problem either (tested down to 70 mm—cans smaller than this might not work as well).Mid PanelsTo increase storage capacity, mid panels were introduced. These allow you to upgrade your setup to hold two sets of cans using the materials required for