Modular Filament holder

Another Filament roll holder.

The "FilamenthalterInnen" are used to put into the filament rolls holes ( dia: 32mm else they have to be adjusted ).
The" nipples" have to be equipped with 8x22x7 ball bearings, secured with flat head M4 screws and washers.
You will need two for every roll.


Depending on how many rolls you want to hang in at the same time you need 2 times
the "Filamenthalter Seite" and for every roll n>=2 another "Filamenthalter Mitte".

For example I am using 2 rolls at the same time, placed 2 "Filamenthalter Seite" at the sides an one "Filamenthalter Mitte" in the middle. If you wanted to place 3 rolls you needed 2 "Filamenthalter Seite" for the sides and 2 "Filamenthalter Mitte" between the rolls.


The holders can be attached directly to the wall, i prefer attaching them on a board, wich is placed at the wall. That makes it easier to level the things.
Make sure the distances between the "Filamenthalter" do not allow to much clearance, that would reduc