Modular Filament shelf/Rack

by nb3d.impressao · Organizers

57 Downloads

36 Likes

17 Makes

I designed a rack-style support to organize my filaments vertically. I used the printed parts together with small 25mm diameter rods to connect the pieces and serve as holders for the filament spools. It can be assembled inside a cabinet, as shown in my photos, or placed on the floor.FeaturesDesigned to minimize filament usageEasy assemblyProfiles for 25mm diameterTested with rods up to 80cm (holding 10 spools), but an additional support piece can be used for larger projectsHeight can be increased at any timePrinting Recommendations0.24mm layer height is sufficient and faster5% gyroid infill2 perimetersRequired MaterialsTwo 25mm rods/tubesTwo side pieces per layer and two rodsTwo connecting pins per layerBoost MeIf you like my work, don’t be shy and leave your boost! I would be very grateful and hope you enjoy my creations.