Thingiverse
Modular Frame Stabilizers
3
Downloads
1
Likes
0
Makes
I'd been thinking about added a some frame stabilization for a while now. I downloaded a few models from here but they were all static and didn't seem to fit my frame geometry. I I built these brackets. They use M5 bolts and nuts, with a washer in between the two PLA parts to prevent rubbing or wear. I replaced the two corner acrylic corner pieces on the left and right sides so there isn't a need for further t-nuts. The spar itself is a 18 mm wooden dowel rod. I'm hoping that it will increase my print quality.
Comments or questions are welcome.
Comments or questions are welcome.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
