Slicer Discord
Modular Hexagon Organizer – 3D-Druckmodell von Thingiverse Thingiverse

Modular Hexagon Organizer

von Emotiva
87 Downloads
74 Likes
0 Makes
Zum Modell
In this remix, I closed the vertical slots to increase the rigidity and reduced wall and base thickness to reduce print time. At 0.7mm line width and 0.3mm layers, the print requires 2 perimeters, 3 base layers, and no infill. It has suited me to utilize only a single 200mm tall model and simply set the slicer to stop at desired height.

The hex 'cells' fit together quite snugly, especially if over-extruding, but I prefer it locked together this way - I haven't had any instances of not being able to tap / whack them into place, and it also allows short cells to be installed up off the table surface.
Quelle
Thingiverse
Was du zum Drucken brauchst: Fortgeschritten Niedrige Konfidenz
Warum?
0.30mm Schichten
Supports 1/3
Zusammenbau 2/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Schichthöhe
0.3 mm
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen