Thingiverse
Modular jumper wire rack
door pjnovas
69
Downloads
42
Likes
0
Makes
Needed a way to hang my wires for prototyping into my Pegboard (used the remix as base design) and after several iterations I left the hooks away and set up M3 holes + nuts.
Main idea here si to print on demand and they will work as modular so no need to guess the amount needed, just attach them next to each other and the sides would work as another rack too.
Holes are meant for a grid of 1 Inch by 1 Inch (pegboard standard). Nuts and holes are for M3 stuff but if you wanna do some changes ~~just ping me and will give link for Fusion360 source~~ below is the link to the source ;)
Fusion360 Link: https://a360.co/2Fbcoeg
** To insert the nut pre-heat it with a solder iron
Main idea here si to print on demand and they will work as modular so no need to guess the amount needed, just attach them next to each other and the sides would work as another rack too.
Holes are meant for a grid of 1 Inch by 1 Inch (pegboard standard). Nuts and holes are for M3 stuff but if you wanna do some changes ~~just ping me and will give link for Fusion360 source~~ below is the link to the source ;)
Fusion360 Link: https://a360.co/2Fbcoeg
** To insert the nut pre-heat it with a solder iron
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
