Thingiverse
Modular model kit stand
by Nadpaddy
22
Downloads
28
Likes
1
Makes
Modular stand for model kits, works with any 3mm attachment point.
The primary arm is designed for strength and stability, the secondary arm is designed for range of motion. Both can be extended for as long as the joints can support the mass. Bases can be attached side-by-side via the fishtail connector piece.
The primary arm requires 3x16mm (1/8x5/8in, may need to drill the holes a little bigger) bolts. All modelled supports snap off with little to no cleanup, additional supports or bed adhesion methods are (generally) not necessary.
ADDITIONS:
Side-to-side swivel top piece for all your sideways dodging and JoJo posing needs.
Top piece for the generic MG action base adapter.
Top pieces for the following kits:
RG Crossbone Gundam
RG Sazabi
RG Hi-Nu Gundam
Note that the kit-specific pieces aren't as refined as the general-purpose ones, so they may need postprocessing to fit.
The primary arm is designed for strength and stability, the secondary arm is designed for range of motion. Both can be extended for as long as the joints can support the mass. Bases can be attached side-by-side via the fishtail connector piece.
The primary arm requires 3x16mm (1/8x5/8in, may need to drill the holes a little bigger) bolts. All modelled supports snap off with little to no cleanup, additional supports or bed adhesion methods are (generally) not necessary.
ADDITIONS:
Side-to-side swivel top piece for all your sideways dodging and JoJo posing needs.
Top piece for the generic MG action base adapter.
Top pieces for the following kits:
RG Crossbone Gundam
RG Sazabi
RG Hi-Nu Gundam
Note that the kit-specific pieces aren't as refined as the general-purpose ones, so they may need postprocessing to fit.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!