Thingiverse
Modular Phone Stand
von prozente
6
Downloads
2
Likes
0
Makes
I made some modular pieces for another project and decided to re-use them and make a phone stand out of them. You will need to print four corner brackets and three middle pieces and one of the two phone holder pieces.
The tolerances on the pieces are tight enough that they will stay together on their own, but not too tight so you can pull them apart if needed.
The corner pieces have threads for M4 screws, they were used on my previous project but not on this one.
The tolerances on the pieces are tight enough that they will stay together on their own, but not too tight so you can pull them apart if needed.
The corner pieces have threads for M4 screws, they were used on my previous project but not on this one.
prozente veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
