Thingiverse
Modular plug holder(s)
von james___uk
0
Downloads
0
Likes
0
Makes
There are two versions of this, a custom long version which you can print as many middle sections for as you like or just the end pieces, and a single version. The example model is meant for show.
A few notes:
- I did my best to not make it overly long but still have enough width for plugs.
- The end-to-end snap fitting is intended for gluing.
- There's a 7mm gap for the cable. With a sloping design to keep it in place unless the plug is overly heavy, I can do a new interation for this if I get around to testing and accommodating for that.
- Designed to be stuck on to a table edge.
- I may implement a print in place sliding latch system later down the line.
A few notes:
- I did my best to not make it overly long but still have enough width for plugs.
- The end-to-end snap fitting is intended for gluing.
- There's a 7mm gap for the cable. With a sloping design to keep it in place unless the plug is overly heavy, I can do a new interation for this if I get around to testing and accommodating for that.
- Designed to be stuck on to a table edge.
- I may implement a print in place sliding latch system later down the line.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
