Thingiverse
Modular Raspberry Pi Cluster Rack & Frame
por ajheyworth
29
Descargas
10
Likes
0
Makes
Thank you to @Krapozok for coming up with a modular Raspberry Pi rack design.
I didn't want to buy the frame that these modules sit within, so printed them!
The frame is still 2U in height, and comes in 8 parts due to the print size restrictions of my Ender 3 Pro, although in hindsight I could have made it in 6. There's the left and right parts (2UFrL & 2UFrR which are actually the same), then top and bottom centre pieces 2UFrTC and 2UFrBC which are again the same.
The pieces bolt together using M4 bolts and nuts. I suggest 14-16mm in length.
Bolts:
https://www.amazon.co.uk/gp/product/B07W49JX1L/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1
The frame includes spacing holes for not just the v1 modules from Krapozok but also anything of half the size, allowing greater mounting options.
It's personal preference, however I suggest brass knurls be purchased (5mm OD, 3mm length, M3 thread) and are press inserted then heat sealed into the frame for module fixings.
K
I didn't want to buy the frame that these modules sit within, so printed them!
The frame is still 2U in height, and comes in 8 parts due to the print size restrictions of my Ender 3 Pro, although in hindsight I could have made it in 6. There's the left and right parts (2UFrL & 2UFrR which are actually the same), then top and bottom centre pieces 2UFrTC and 2UFrBC which are again the same.
The pieces bolt together using M4 bolts and nuts. I suggest 14-16mm in length.
Bolts:
https://www.amazon.co.uk/gp/product/B07W49JX1L/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1
The frame includes spacing holes for not just the v1 modules from Krapozok but also anything of half the size, allowing greater mounting options.
It's personal preference, however I suggest brass knurls be purchased (5mm OD, 3mm length, M3 thread) and are press inserted then heat sealed into the frame for module fixings.
K
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!