MakerWorld
Other House Models
Ver Modelo
Modular Shoe Shelf 2 Piece
180
Descargas
75
Likes
35
Makes
Kosh had a good design, but was too small for my needs. My design is printed in two pieces, which gives you more room for bigger shoes and hiking boots. These shelves have a 9 in [228.5 mm] x 11 in [279.4 mm] foot print.The shoe shelf is 7.2 in [182.88 mm] high. The boot shelf is 9.8 in [248.92 mm] highThere are three pieces to my design. Customize to your needs:Boot shelfShoe shelfShims for stacking shelves side-by-side4mm screws are neededNOTE: I was going to create a stabilizer for the bottom to increase the footprint and improve the stability for vertical stacking. However, I didn't need it for my application so I never got around to it. Also, I built in “mickey mouse” ears on the corners to decrease warping for ABS printing. These worked very well. Just cut them off after printing. I included the .f3d model in the files.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!