Thingiverse
Modular Shot Glass Holder
von DBarbs
31
Downloads
24
Likes
0
Makes
Modular shot glass holder!
This assumes a shot glass is 50mm X 60mm.
The modules leave 20mm of room on top for grabbing the glasses out.
Perfect for collectable shot glasses or just storage on a bar. I suggest using epoxy (Preferably) or super glue to attach them together then using ten pound (Or stronger) double sided tape if mounting to a wall.
I may add dovetail slides in soon so they can be locked together, feel free to remix it and post!
No supports needed during printing
*****VERSION 1.0.1*****
Someone suggested adding a lip to prevent from shot glasses falling out. This updated file can be downloaded as ShotGlassModuleWithLip.stl
*****
This assumes a shot glass is 50mm X 60mm.
The modules leave 20mm of room on top for grabbing the glasses out.
Perfect for collectable shot glasses or just storage on a bar. I suggest using epoxy (Preferably) or super glue to attach them together then using ten pound (Or stronger) double sided tape if mounting to a wall.
I may add dovetail slides in soon so they can be locked together, feel free to remix it and post!
No supports needed during printing
*****VERSION 1.0.1*****
Someone suggested adding a lip to prevent from shot glasses falling out. This updated file can be downloaded as ShotGlassModuleWithLip.stl
*****
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
