Thingiverse
Moebius ring
di pmaegerman
530
Download
533
Likes
6
Makes
A moebius ring, after a few trials, this is what worked for me :
shell 2mm
infill 20%
Support ( cura ) overhang angle : 50°
Printed at 70mm/s .2mm resolution.
I tried no infill, forget about it, you'll waste plastic ;)
1.2mm shell was too thin in some spots where the angle is very low.
How to design this in blender : https://www.youtube.com/watch?v=s6Jqb4dIV9g
shell 2mm
infill 20%
Support ( cura ) overhang angle : 50°
Printed at 70mm/s .2mm resolution.
I tried no infill, forget about it, you'll waste plastic ;)
1.2mm shell was too thin in some spots where the angle is very low.
How to design this in blender : https://www.youtube.com/watch?v=s6Jqb4dIV9g
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
