Thingiverse
Moisture Sensor Drybox Bracket
von Sileflas
0
Downloads
1
Likes
0
Makes
Designed this for the sensor shown in the pictures above. (Secrui Model: KR-TH1)
Found it on amazon for fairly reasonable price.
Used 3 imperial measurement 6-32x1/2" machine screws (why do they call it a screw when it comes with a nut, wouldn't that make it a bolt?) because metric stuff that tiny is hard to find around here! A 3.5mm screw will most likely work as well since it's a tiny bit smaller I think.
The nuts fit pretty snug into the recesses so you may need to use some pressure to squeeze them in place.
Found it on amazon for fairly reasonable price.
Used 3 imperial measurement 6-32x1/2" machine screws (why do they call it a screw when it comes with a nut, wouldn't that make it a bolt?) because metric stuff that tiny is hard to find around here! A 3.5mm screw will most likely work as well since it's a tiny bit smaller I think.
The nuts fit pretty snug into the recesses so you may need to use some pressure to squeeze them in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!