Slicer Discord
Mole trap (grab it alive) – Modelo 3D imprimible de Thingiverse Thingiverse

Mole trap (grab it alive)

por zsoros
89 Descargas
61 Likes
1 Makes
Ver Modelo
This simple trap grab the mole alive so do not worry about it.

Print: all the parts must be align on the flat surface except the frame.
I aligned the frame on the outside. that need just a few support while printing.

- Screw 2 pieces of M5 nuts on the doors. This weights keep the door in closed position,
- Put 2x 3mm diameters x 28mm long of shaft in the frame to hold the door,
- insert the two assembled frames each end of the pipe glue it if needed. make sure the doors be parallel.
- When you use the hinge must be on top. The doors must be open and close easy.

Do not kill animals!
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Confianza media
¿Por qué?
ensamblaje de 2 piezas · postproceso considerable
Tornillería requerida
Soportes 1/3
Ensamblaje 1/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 2/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Cama mín.
50 mm (Pequeño)
Postprocesado
Pegado, Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección