Thingiverse
Music
Model downloaden
Monitor Headphone Stand
10
Downloads
9
Likes
0
Makes
A headphone holder that sits on top of a monitor
2 Piece Design. The small part should be adjusted to suit the angle of the back of the monitor. This can be adjusted by :
1. stuffing the hole on the bigger piece. you can then decide to glue it so it doesnt come off
2. drill a hole on the bigger piece and put a screw to secure the smaller piece on the desired height.
a rubber tape of some sort can be taped on places where it touches the monitor for improved grip and to not scratch the surface. I personally used a thin weather stripping Foam I got from aliexpress.
I may improve it eventually when I have time. but at its current form, it works so I might just leave it.
2 Piece Design. The small part should be adjusted to suit the angle of the back of the monitor. This can be adjusted by :
1. stuffing the hole on the bigger piece. you can then decide to glue it so it doesnt come off
2. drill a hole on the bigger piece and put a screw to secure the smaller piece on the desired height.
a rubber tape of some sort can be taped on places where it touches the monitor for improved grip and to not scratch the surface. I personally used a thin weather stripping Foam I got from aliexpress.
I may improve it eventually when I have time. but at its current form, it works so I might just leave it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
