Monitor Kickstand

I remixed a monitor kickstand to fit my monitor. The holes on this bracket are 75mm apart.

The leg is 8in long, so it should work for monitors 10in to 14in tall, depending on the angle you want.

This piece will require a 4mm bolt at least 2.5in long and a nut (ideally a locknut, but a standard hex nut will do).

I also included some small (1/4in tall) spacer bricks that elevate the monitor, so you can run cords under it.

As with the original design, you'll want some kind of double-sided tape or foam adhesive to prevent the leg from slipping.

I also included the Fusion 360 files, if you need to modify the design.