MakerWorld
Office
Zum Modell
Monitor Stand II
50
Downloads
23
Likes
15
Makes
// NOTE: When first printing, print a few layers as a draft to ensure it fits nicely. I recommend making it the same layer height as the full print you plan to print; tolerances will change depending on layer height. I recommend a 0.2 or 0.16 layer height or lower to ensure the board fits.The stand is meant for a 7.25 in. x 0.75 in. board. They are 1 in. thick, and the thickness can be adjusted easily if needed. 4.51 in. tall in total.3.50 in. tall underneath the board.7.75 in. wide in total. Boost MePlease comment if you have any suggestions or improvements you would like to see.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
