Thingiverse
monitor wall mount
von seppa
53
Downloads
39
Likes
0
Makes
Please have fun printing your own monitor or TV wall mount.
The wall mount is fixed by 4 bolts (M4) to your device, and another 4 screws to the wall/cabinets.
The mount is designed to tilt in one direction only. Either sideways or up&down.
The mount holes are spaced evenly 100mm apart. the mount itself is 130mm(X) by 130mm(Y) by 52mm(Z)
The attached knob can be used to tighten the fixture using a 120mm M8 Bolt.
The wall mount is fixed by 4 bolts (M4) to your device, and another 4 screws to the wall/cabinets.
The mount is designed to tilt in one direction only. Either sideways or up&down.
The mount holes are spaced evenly 100mm apart. the mount itself is 130mm(X) by 130mm(Y) by 52mm(Z)
The attached knob can be used to tighten the fixture using a 120mm M8 Bolt.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
