Monkey - Geometric Wall Hanger

This was printed in Creality Carbon Fiber PLA in grey because I’m a sucker for the finish on carbon fiber filament. Used 10% infill with the gyroid pattern since it is fairly straightforward and used a 0.20 layer height. Obviously, no supports are needed. Looks great on a wall and can be hung or attached with double sided tape. I like to display them build plate side up. The texture also takes spray paint really well! Takes about an hour and thirty three minutes on a K2+ at full size. If you resize, I suggest keeping it at about 3mm z depth. Best to let the build plate cool, or you may get some bowing when you remove it.