Thingiverse
Mono Apple speaker
von smejch
20
Downloads
15
Likes
0
Makes
For all those apple crazies around :-) this is a one-piece printed enclosure designed to be operated as a simple mono speaker using TEBM65C20F-4 fullrange and cheap digital amplifier board. there are two inputs - signal (3,5 Jack-TRS) and DC power (2.1/5.5 mm connector)
I´ll probably work on some other versions (looking at DAYTON AUDIO PS95-8) which should also reduce footprint to fit Prusa MK3. Now it is roughly at 225x225x210 mm.
0.5 nozzle and 0.28 layer height gets you to about 800g of PLA and 35 hours of print time.
EDIT: second smaller and tidier version added.
-fits mk3
-has inner screw posts to hold the amplifier board
-bassreflex hole - fits any 32/28 mm tube (8 cm long piece should do the trick)
-inner support structure has to be cut out and top hole drilled through after printing
I´ll probably work on some other versions (looking at DAYTON AUDIO PS95-8) which should also reduce footprint to fit Prusa MK3. Now it is roughly at 225x225x210 mm.
0.5 nozzle and 0.28 layer height gets you to about 800g of PLA and 35 hours of print time.
EDIT: second smaller and tidier version added.
-fits mk3
-has inner screw posts to hold the amplifier board
-bassreflex hole - fits any 32/28 mm tube (8 cm long piece should do the trick)
-inner support structure has to be cut out and top hole drilled through after printing
smejch veröffentlicht auch auf
24 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
