Thingiverse
Mono X Vent Adapter
von mattycakez
22
Downloads
9
Likes
0
Makes
!!!You'll need to flip your fans for this adapters to work!!! There are 4 fans in all.
The bottom fans will need little risers to lift off the bottom, which are included here.
Here's a link on how to do it: https://youtu.be/p2QjTJqcA-8
No supports needed.
Diameter of end is 3 inches.
This eliminates ALL fumes. I'm testing this right now. Wife confirms. The printer is covered with a small blanket, the blanket didn't help at all in the past.
The bottom of the mono x has 4 big holes in it. Tape those up and tape up anything where fumes may leak. This print fit snug on one side, but the other had a 0.5mm gap. I taped that.
The bottom fans will need little risers to lift off the bottom, which are included here.
Here's a link on how to do it: https://youtu.be/p2QjTJqcA-8
No supports needed.
Diameter of end is 3 inches.
This eliminates ALL fumes. I'm testing this right now. Wife confirms. The printer is covered with a small blanket, the blanket didn't help at all in the past.
The bottom of the mono x has 4 big holes in it. Tape those up and tape up anything where fumes may leak. This print fit snug on one side, but the other had a 0.5mm gap. I taped that.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!