Monoprice Maker Ultimate 2 Spool Holder

Some spools do not fit inside the Maker Ultimate 2, so designed these in Tinkercad to support a pipe holding the spools above the printer. Print 2 spool holders and 2 braces. The braces go in the printer above the top rail, and below the case. They prevent the tower from tipping over. You could alternatively use a machine screw to hold the tower, but this allows it to be adjusted front to back, and works just as well if not better.

I am going to add a detachable filament guide at some point. for now, I just put a 6 inch piece of PTFE tube over the filament to keep it from kinking or twisting between the roll and the hot end assembly.