Thingiverse
MonoPrice MakerSelect LCD Relocation
por Edyck
0
Descargas
0
Likes
0
Makes
This is a mount for the LCD when case is removed. I designed to slip under the front lip ONLY if you have the support braces installed. (Assumes a 8.5mm gap)
*******THIS ASSUMES YOU HAVE A Z BRACE INSTALLED. GAP FROM TABLE TO CROSS BRACE REQUIRED******
I ordered a 3-ft, 10-pin cable for less than $10.00 for 2.
*******THIS ASSUMES YOU HAVE A Z BRACE INSTALLED. GAP FROM TABLE TO CROSS BRACE REQUIRED******
I ordered a 3-ft, 10-pin cable for less than $10.00 for 2.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
