Monoprice Mini Bed Upgrade

These parts make up a total bed exchange for a Monoprice Mini. This add manual leveling to mine, which did not have it.

Check out the assembly video: https://youtu.be/7QtzCL9a45Q

\** UPDATED 1/3/2021 \**
Heated Bed Upgrade: https://www.thingiverse.com/thing:4726170

All parts fit on the printer. I printed them using PLA. Used a 15% cubic infill for all parts.
The rod clamps and bed trays need a brim.
Bed ends should be printed on their back, with supports.

This can also be used to extend the bed in the y-direction by replacing the linear rods and increasing the length of the tray spacers.
Relationships for increasing the bed length:
Bed = Rod - 30
Spacer = Rod - 62
Spacer = Bed - 98
Rod = Bed + 30


Parts:
(2) Bed Ends
(4) Rod Clamps
(2) Belt Clamps
(2) Bed Trays
(2) Tray Spacers

Hardware:
(20) 20mm M3 screws
(20) M3 nuts
(8) M3 washers
(2) Pens springs, cut in half
Belt (about 30cm)
Tensinoer (reuse from printer)
Linear Rods (reuse from printer