Monoprice Mini Delta E3d Clone mount

1/17/2020 1730 version 3 will be posted in a few minutes. each gets own post as they are ground up new designs.

8/19/2019 1030 Added another Deep Base but with room for 3mm Hex nuts.

6/29/19 1540 added a deep base version for extra strength, haven't printed but only took two minutes to modify and export. 9/9/2019 1900. I have since printed and did use it until I did the hex nut version approx 60-70 print hours.

I got an e3d clone hotend and adapted it for the MPMD. I made a bunch of them and a bunch of different versions. I said that if I was going to do it again I would start from the ground up, and that is what I did. This time I was a little smarter. I made each of the main pieces separately and then put them all together and then printed. I made a crucial error on placing the e3d and had to re-adjust and re-print. The one in the photo is printing the one I just uploaded, the only difference is when attaching the lock fan to the base it cracked at the screw holes so I beefe