Thingiverse

Monoprice Mini Spool Holder

by techappsgoodson

133 Downloads

97 Likes

2 Makes

Sometimes I have to use reels that have very small holes. I took inspiration from several designs to create a holder that could fit a reel with an opening of 30mm but still strong.

Uses typical 608 fidget spinner bearings. Can be printed on the Mini printer with supports. I used simplify3d to print the bottom at about 50% fill then reduced to 30%. I put a drop of hot glue on the pegs to make sure I don't lose any bearings.

Mods for Monoprice monoprice monoprice makerselect Monoprice mini monoprice select mini MPSM MPSM V1 MPSM V2 mp mini Mp select mini mp select mini v2 Mods for Monoprice monoprice monoprice makerselect Monoprice mini monoprice select mini MPSM MPSM V1 MPSM V2 mp mini Mp select mini mp select mini v2

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Why?

supports needed · significant post-processing

Single piece Supports required Hardware needed

Supports 2/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 2/3

Printer