Monoprice Select Mini Elevated Base

So I wanted to add a 150w PSU, Raspberry Pi, a fan or two, and some other stuff to my Mini. Clearly this wouldn't all fit inside the bottom of this printer, so I decided to add more bottom to the printer! This adds 84mm of internal volume vertically and raises the entire printer about 95mm with the rubber feet I added.

Components installed

Mean Well LRS-150-12 150W power supply
IEC320 power outlet/switch
Raspberry Pi 3
eBoot Mini MP1584EN buck converter (5v power for Pi)
Phobya 4-Pin to 6 x 3-Pin Fan Splitter
Noctua NF-A9 FLX 92mm fan
Scythe 100mmx12mm fan
Toowei T701A front side power switch
1/4"x11/16" rubber feet
Power/reset/LED PCB scavenged from old computer to control Pi

I'm including the design files in case anyone wants to modify to match their components. You may have to ream out the holes on the sides that connect to the pringer to match your holes, and using washers there is recommended. There is a ridge on the left side moduleon the front wall where the PS