Thingiverse
Monoprice Select Mini Foot
von portlandandy
19
Downloads
6
Likes
0
Makes
This is my first 3D design!
We lost one of the rubber pads on the bottom of our Monoprice, leaving an exposed screw head to scratch up our tabletop.
This simple foot attaches with the current hardware, just remove the rubber pad and use the screw that's already there!
It will raise the printer 1cm off the tabletop and should prevent scratches if you move the printer around.
We lost one of the rubber pads on the bottom of our Monoprice, leaving an exposed screw head to scratch up our tabletop.
This simple foot attaches with the current hardware, just remove the rubber pad and use the screw that's already there!
It will raise the printer 1cm off the tabletop and should prevent scratches if you move the printer around.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!