Monoprice Select Mini V2 Back panel

I wanted a removable back cover with out having to take the bottom off the machine.
I printed this in PETG.
Once it was finished. I ran some very small self tapping screws in the bottom back two holes, they act as alignment pins. For the top I used a hot putty knife to "weld" some reinforcements under the screw holes for the top side. I then got the thick side of a cleaning needle red hot and poked holes in the plastic where I needed to thread the self tapping screws.
I assume the same principal could be done to the metal cover but the machine is noisy enough as it is, so I opted for plastic