Thingiverse
Monotub Vent
von JBA_411
8
Downloads
18
Likes
0
Makes
The Air Vent design by G4ZO is great, I just didn't want to glue it to the container I am using for my monotub. Added a threaded section that the moving vent attaches to and designed it with an inlay for a 58mm filter.
Used a 65mm hole bit to cut out the plastic and cleaned it up with a hobby knife.
Used a 65mm hole bit to cut out the plastic and cleaned it up with a hobby knife.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!