Monster Jam Logo Lightbox

This lightbox is 22 cm x 17 cm x 3 cm at its full scale. It prints in two halves that can be easily snapped together without glue or hardware. There is a hole in the back for a LED cord to be connected through. You could alternatively add a side hole in your slicer if that is preferred. I used the four bambu labs filaments listed on this page, but I might suggest a more vibrant yellow to better match the original logo's colors. Our lightbox is currently hung on the wall of my four-year-old son's wall as he is obsessed with everything Monster Jam. NOTE: This logo is not licensed and therefore cannot be used commercially. For the best results, I highly recommend doing the following:Clean your build plate thoroughly before starting to get the best adhesionUse a very slow print speed on the first layer, again for good adhesion (something like 15-20mm/s)Let the print fully cool before trying to remove either half from the print bed to avoid warpingThis lightbox was originally create