Monster LED remote holder – 3D printable model from MakerWorld MakerWorld
Electronics

Monster LED remote holder

13 Downloads
4 Likes
4 Makes
Download Model
SummaryDollarama had these kits for $4, so I'm going to add them to my cabinet.This piece should give me a place to store the remote.May be very tight fit.Works great, but if you jam the remote in there tight it is hard to remove, good but also possibly bad.Sanding the inside or bumping up the print size by a percent or two is advised.
Category
Electronics
Source
MakerWorld
Published
10.09.2024
Updated
23.01.2026
Comments
0
Makes
0

Makes

Rating

Noch keine Ratingen

Comments

No comments yet – be the first!
More Electronics Models All MakerWorld Models More by unhooked

Similar Models

6 Suggestions

Add to Collection