MakerWorld
Sculptures
Model downloaden
Monster Skull
2.1k
Downloads
1.2k
Likes
1.1k
Makes
Hi guys, hope you like this new monster skull:) The print profile is prepared for a width of 200mm, feel free to scale it if you would like to print it bigger or smaller. I recommend to use pliers to carefully remove the support, especially around the small spikes around the head. I know they are very thin, but I really like the look of them. In the worst case that one would break, you could simply remove the one on the other side as well, I think this will be very subtle. There is a hole in the back for wall mounting this sculpture:) If you would like to sell prints of my models check out my commercial license my Patreon: https://www.patreon.com/c/TreeDprintsAlso check out my other models here: https://makerworld.com/en/@TreeDprints
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
