Thingiverse
Monstera Sliding Door Lock
by jamespx4
1
Downloads
12
Likes
0
Makes
Monstera sliding closet lock printed in matte PLA on ender 3 - 0.2mm layer height, 50% infill.
Tolerance for the latch was too tight - adjusted the Z and Y axis scaling to 95% for the latch model in cura and it fits almost perfectly.
Tolerance for the latch was too tight - adjusted the Z and Y axis scaling to 95% for the latch model in cura and it fits almost perfectly.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
