Monstertech Custom wall mount

I found that my monstertech mounts got in the way even when swiveled out of the way. I asked a friend to design this simple mount in CAD for me. I have been using an older version for about a month now and it works great. This updated version is even better and keeps the hotas further from the wall so you don't scratch the wall like the older version could if you were not careful. I would print this at 100% infill for maximum strength. I found that not all monstertech tslots are built the same and it slides easily into some and is quite difficult to slide into others. If you find it difficult to slide in I would just slide it in and out a bunch until it gets easier. I used drywall screws and put the middle two screws into a stud and the outer 4 into drywall anchors (drywall anchors might have been overkill but the hotas are expensive). I highly recommend that you put at least two of the 6 screws into a stud to make sure that this thing doesn't go anywhere.