Thingiverse
Moon lamp base
par miroan81
5
Téléchargements
2
Likes
0
Makes
Moon base that uses 3d printed e27 bulb throat from here https://www.thingiverse.com/thing:4235261
On the picture is 8" Moon, the base should be fine for smaller 6 or 7" as well
Other parts needed are 2 M2x10 screws, AC cable and a led bulb, preferably thinner one so the hole in the Moon doesn't have to be any bigger than needed
Refer to pics for all parts I used
No supports needed, any printer can do bridging quite well, 1st layer beneath may not look perfect but others will and there's plenty of meat in the middle (3mm). I did 2 walls, 4 top and bottom, 5% infill, 50 grams of pla was needed for the base.
E27 throat was printed in petg
On the picture is 8" Moon, the base should be fine for smaller 6 or 7" as well
Other parts needed are 2 M2x10 screws, AC cable and a led bulb, preferably thinner one so the hole in the Moon doesn't have to be any bigger than needed
Refer to pics for all parts I used
No supports needed, any printer can do bridging quite well, 1st layer beneath may not look perfect but others will and there's plenty of meat in the middle (3mm). I did 2 walls, 4 top and bottom, 5% infill, 50 grams of pla was needed for the base.
E27 throat was printed in petg
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !