Thingiverse
Moon Light Stand
by LeatherWing
47
Downloads
46
Likes
0
Makes
A base for the 5" moon from moononournation with an Arduino Uno in the base controlling 4 RGB LEDs with schematics.
The Clips for the Arduino drawer hold very well, to well in fact to easy remove it if wiring needs fixed. Don't snap it in until you are sure everything is wired and working correctly.
The Pots and LEDs came from Adafruit, I used marmils knobs but had to print them at about 95% on x and y to get a good fit.
https://youtu.be/-ybm8vtPFe0
The Clips for the Arduino drawer hold very well, to well in fact to easy remove it if wiring needs fixed. Don't snap it in until you are sure everything is wired and working correctly.
The Pots and LEDs came from Adafruit, I used marmils knobs but had to print them at about 95% on x and y to get a good fit.
https://youtu.be/-ybm8vtPFe0
LeatherWing also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
