Moon Rise

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 4.5mm Filaments Used: PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Beige Transmission Distance: 8 PLA BambuLab Basic Jade White Transmission Distance: 5 PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Silver Transmission Distance: 0.5 This print uses 7 unique filaments. Substitute as needed. Swap Instructions: Start with Red At layer #12 (1.04mm) swap to Orange At layer #15 (1.28mm) swap to Beige At layer #21 (1.76mm) swap to Jade White At layer #25 (2.08mm) swap to Black At layer #33 (2.72mm) swap to Jade White At layer #35 (2.88mm) swap to Blue Gray At layer #40 (3.28mm) swap to Jade White At layer #44 (3.6mm) swap to Silver At layer #48 (3.92mm) swap to Jade White for the rest.