Moonlander special key

# Moonlander Red Key Replacement

I wanted a cap that was easier to reach with my thumb. I took inspiration from a existing cap. In the end the cap is still bit hard to reach with the thumb, but feels more usable.

## Files

Scad file included if you need to do adjustments to the design or want to remix this!

### Moonlander 16

This cap has the settings for 16mm height and -20 degree angle on scad. I found that this key size was good for me. It is higher than the rest of the keys on the thumbcluster.

### Moonlander 11

This cap should be roughly the same height as the other buttons on the moonlander, but has the same lean as 16. Note I have not printed this and cannot verify if the measurements are correct.

### Moonlander flat

The flat file is a replacement for the original keycap. I have not printed this and cannot verify if the measurements are 100% correct.