Moonlander Wrist Support Small

I printed the Moonlander Wrist support towers from @joh_7010 and they were too big for me.This model was recreated by me and I followed the originals design but made it 2 cm at its thickest point.The slope has also been adjusted for the new height.I recommend these for people that use the ZSA Moonlander with a less aggressive tilt angle. The magnets are 8x2mm. Update:I found out that @joh_7010 did an amazing job and his version actually includes variables that can be adjusted. So if you want something custom I recommend you use his model.