Thingiverse
Morphite V2 Runcam Swift Camera Mount
by KAPCOM
4
Downloads
2
Likes
0
Makes
This is a very simple, low weight camera mount for the Armattan Morphite V2 frame.
To assemble, glue two #2 nuts into the corresponding holes (or, if you print at a high enough detail, just insert them without glue and the plastic will hold them in place) and assemble the mount into the curved slot shown. This was designed to be put together with the same hardware used to assemble the camera mount that came with the frame. I would recommend attaching the camera to the mount before assembly into the frame.
Hope this helps! If you've got any suggestions, leave them in the comments!
To assemble, glue two #2 nuts into the corresponding holes (or, if you print at a high enough detail, just insert them without glue and the plastic will hold them in place) and assemble the mount into the curved slot shown. This was designed to be put together with the same hardware used to assemble the camera mount that came with the frame. I would recommend attaching the camera to the mount before assembly into the frame.
Hope this helps! If you've got any suggestions, leave them in the comments!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
