MakerWorld
Decor
Model downloaden
Mosaic Lamp
50
Downloads
61
Likes
0
Makes
There are two configurations of this model you can make. Each one will require six bottom panels and six top panels. Tree supports were used when printing the lamp center part. I would suggest using z-hop when printing the frame part. Each piece was printed with 5% infill, a .2mm layer height, at 30mm/s. You can use any standard led tealight or rgb tealight.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
